D-Link DIR-809 User Manual page 79

Section 3 - Configuration
Select either Obtain DNS server address automatically or Use the following DNS address.
If you choose Use the following DNS address, please configure the following field:
Primary DNS Enter the primary DNS server address.
Address:
Secondary DNS
Enter the secondary DNS server address.
Address:
LAN IPv6 Address Settings
Enable DHCP-PD: Check this box to enable DHCP-PD.
LAN IPv6 Address: Enter the LAN (local) IPv6 address for the router. Not available if
DHCP-PD is enabled.
LAN IPv6 Link- Displays the router's LAN link-local address.
Local Address:
D-Link DIR-809 User Manual
IPv6 in and IPv4 Tunnel (continued)
IPV6 DNS SETTINGS IPV6 DNS SETTINGS
Obtain DNS server address automatically or enter a specific DNS server address.
ž Obtain IPv6 DNS Servers automatically
š Use the following IPv6 DNS Servers
Primary DNS Address :
Secondary DNS Address :
LAN IPV6 ADDRESS SETTINGS
Use this section to configure the internal network settings of your router. If you change the LAN IPv6 Address here, you may need to
adjust your PC network settings to access the network again.
Enable DHCP-PD :
LAN IPv6 Address :
LAN IPv6 Link-Local Address : ffff::fff:ffff:ffff:1234 /64
ADDRESS AUTOCONFIGURATION SETTINGS
Use this section to setup IPv6 Autoconfiguration to assign IP addresses to the computers on your network. You can also enable DHCP-PD
to delegate prefixes for routers in your LAN.
Enable Automatic IPv6 address assignment :
Enable Automatic DHCP-PD in LAN :
Autoconfiguration Type : SLAAC+RDNSS
SLAAC+Stateless DHCP
Stateful DHCPv6
Router Advertisement Lifetime :
Save Settings Don't Save Settings
/64
▼
(minutes)
75