Mounting The Host Usb Converter; Connecting The Hardware; Figure 2-2 Host Usb Converter Mounting Details - Northern Digital Polaris Vicra User Manual

2.4

Mounting the Host USB Converter

The Host USB Converter can be free-standing or may be mounted via M6 x 1 mm pitch x 4 mm
deep threaded holes located in the three mounting feet.
mounting arrangement, with dimensions.
88
57
2.5

Connecting the Hardware

Note
It is good practise to disconnect the mains power before connecting or disconnecting cables.
1. Connect the Position Sensor cable (attached to the Host USB Converter) to the connector
located on the back of the Position Sensor. Align the red marking on the Position Sensor
connector with the red marking on the cable connector (the double keys of the connectors
should be aligned).
2. Connect the USB cable B plug and power adapter cable to the Host USB Converter, as shown in
Figure 2-3.
3. Locate the top and bottom cable covers in place on the Host USB Converter. Secure the covers
with the thumbscrew, as shown in
Polaris Vicra User Guide - Revision 2
40
See Detail A

Figure 2-2 Host USB Converter Mounting Details

Figure 2-3.
Setting Up the Polaris Vicra System
Figure 2-2 shows the Host USB Converter
28.53
42
Detail A
All dimensions in mm
M6x1x3
3Places
51
64
19