1.3
Host USB Converter
The Host USB Converter provides the interface between the Position Sensor, the power adapter,
and the host computer:
•
The attached Position Sensor cable connects the Host USB Converter to the Position Sensor.
•
The power adapter and USB cable plugs into the Host USB Converter.
•
Modem status bits are provided see
Power Connector
The Host USB Converter incorporates the sub-assemblies detailed below.
Cable Covers: Two covers (top and bottom) that are secured together by means of a thumbscrew.
The covers retain the USB and power adapter cables in place.
Position Sensor Cable: Provides connection for data and power between the Position Sensor and
Host USB Converter. This cable is permanently connected to the Host USB Converter and is either
4.5 m or 8 m, depending on the configuration of your system.
Power Indicator: Lights green when power is applied to the Host USB Converter.
Error Indicator: Lights amber when the Host USB Converter has detected a fault.
Mounting Feet: Three feet that incorporate an internal thread (M6 x 1 mm pitch x 4 mm depth) to
allow the Host USB Converter to be attached to an external structure (for example, a cart). For free-
standing use, rubber inserts are located in the mounting feet.
Polaris Vicra User Guide - Revision 2
Position Sensor Cable
Indicator LED
(Error)
Figure 1-6 Host USB Converter
"Serial Port Emulation" on page
Mounting Feet x 3
Cable Covers
(top and bottom)
USB Connector
Polaris Vicra System Overview
40.
Indicator LED
(Power)
11