Alarm Messages; Preventive Maintenance; Connectivity Kit - Electrolux thermaline ProThermetic PFET electric Installation And Operating Manual

Touch screen calibration
This setting allows to set the calibration of the
screen.
• Touch the screen as close as possible to the centre of
the red cross;
• Repeat until the cross turns green;
• Touch and hold to exit.
K.3.10 Alarm messages
Any errors or alarms and their brief description are shown on
the display with the icon
An acoustic signal is played simultaneously.
K.3.11 Preventive maintenance
If available for your model, an alert can be set, which informs
you when it is time for maintenance based on the number of
cooking cycles, hours the appliance has been in operation, or
days/months passed. Refer to the Service Manual or contact
Customer Care Service.
K.4

Connectivity kit

If the connectivity kit is present, connect the Ethernet cable
and check in the touch panel settings that parameter no. 40 is
set correctly, refer to the "Parameter Setting" document.
First remove the user interface panel referring to E.5 Access-
ing the appliance's internal components.
Then insert the Ethernet cable into the factory-fitted connector.
Fig. 1 Ethernet cable into connector
IMPORTANT
If the appliance has feet, insert the Ethernet cable
through the cable gland already mounted:
1. Remove the cable gland from its position.
.
2. Place the Ethernet cable inside the cable gland.
3. Reassemble the cable gland in its original position.
4. Insert the Ethernet cable into the factory-fitted connector,
refer to Fig. 1 Ethernet cable into connector.
5. Remount the user interface panel.
6. Through the touch panel, enter in "Settings" mode (refer-
ring to K.3.9 Settings) and tap on
7. Insert the password, refer to the Service Manual or
"Parameter Settings" document.
8. Click on "Appliance parameters" and then scroll down until
you reach parameter no. 40.
40. ADDR Isolated RS485 port address
.
Settings
Service
Alarm log
Appliance status
Appliance parameters
Identity card
Reset User password
Settings
Appliance parameters
1. SEC Clock: seconds setting 0
2. MIN Clock: minutes setting 0
3. HOUR Clock: hours setting 0
4. DAY Date: day setting 0
5. MON Date: month setting 1
1
31