Customer Packaging Checks; Storage; Einstallation Diagrams; Installation Type - Electrolux thermaline ProThermetic PFET electric Installation And Operating Manual

D.9

Customer packaging checks

• The forwarder is responsible for the goods during transport
and delivery.
• Make a complaint to the forwarder in case of visible or
hidden damage.
• Specify any damage or shortages on the dispatch note.
• The driver must sign the dispatch note: the forwarder can
reject the claim if the dispatch note is not signed (the
forwarder can provide the necessary form).
• For hidden damage or shortages becoming apparent only
after unpacking, request the forwarder for inspection of the
goods within and no later than 15 days after delivery.
After packaging checks
1. Remove the packaging.
E INSTALLATION DIAGRAMS
E.1

Installation type

The appliance must always be installed in its intended location
according to the relevant installation and connection diagrams
(E INSTALLATION DIAGRAMS).
The appliance should be connected to fixed cables.
Installation options:
1. Standing against the wall
• on adjustable feet
• on steel bases
• on concrete plinth
2. Free standing
• on adjustable feet
E.2

Dimension drawing for floor and wall installation

E.2.1

Installation points

Floor installation
80 80
FP
FP = floor attachment points
E.2.2

Dimensions

A
1040
1240
1440
E.3

Drain floor

E.3.1

Floor diagram

For these appliances, the emptying area is provided with tanks equipped with a movable upper grate and a floor drain, to be used
during cleaning.
Floor tanks can be manufactured for a single appliance or for an entire group of appliances.
A
80 80
FP
B C D
500 150 800
500 200 850
600 150 900
Take care when unpacking and handling of the appliance
to not cause any shocks on itself.
2. Keep all the documentation contained in the packaging.
D.10 Storage
The appliance and/or its parts must be stored and protected
from damp, in a non-aggressive place, free of vibrations and
with room temperatures between 5℃ and 50℃.
The place where the appliance is stored must:
• can take the appliance load,
• have a flat support surface to avoid deforming the appliance
or damage to the support feet.
• on steel bases
• on concrete plinth
3. Wall mounted
(with an accessory kit)
The appliances are suitable for setting up as single appliances
or as a group of appliances.
NOTE!
When installing the appliance on a steel or con-
crete plinth, the bottom plate must not be mounted.
The ventilation engineer is responsible for assessing/planning
a technically correct ventilation.
Wall installation
100
WP
WP = wall attachment points
A
1000
1200
1400
A
100
WP
13