Wavetronix Click 110 Manual page 18

The Click 110 can be configured using the Expert driver (see the figure below).
After you have made configuration changes on the driver and saved it to the Click device, the word "current" will
appear after it to indicate the driver is currently loaded onto the device.
The Backups option can be used to read configurations that have previously been saved to file.
Expert Driver
The Expert driver contains two tabs, System and Diagnostics; the System tab is then subdivided further.
The System > General tab lets you change general information about your device. The tab has the following
parameters (see the figure and table below):
Note. This parameter can only be configured using Click Supervisor.
Setting
Module
Driver
Description
Location
Serial Number
WX-501-0517 • 05.22
Description
Allows you to enter a name and description of the device.
Names the driver you are currently working with.
Shows a description of the device being configured. This is only for your information and does not
affect the operation of the device.
Displays the location of the device being configured. This is only for your information and does
not affect the operation of the device.
Displays the serial number of your device. This information cannot be changed.
18 of 20