Table of Contents
Advertisement
Avg� Platform Center Offset: The average platform center
offset for the current activity.
Avg� Right Peak Power Phase: The average power phase
peak angle for the right leg for the current activity.
Avg� SOG: The average speed of travel for the current
activity, regardless of the course steered and temporary
variations in heading.
Balance: The current left/right power balance.
Barometric Pressure: The current calibrated
environmental pressure.
Battery Level: The remaining battery power.
Bearing: The direction from your current location to a
destination. You must be navigating for this data to
appear.
Cadence: Cycling. The number of revolutions of the
crank arm. Your device must be connected to a
cadence accessory for this data to appear.
Cadence: Running. The steps per minute (right and left).
Calories: The amount of total calories burned.
COG: The actual direction of travel, regardless of the
course steered and temporary variations in heading.
Compass Heading: The direction you are moving
based on the compass.
Course: The direction from your starting location to a
destination. Course can be viewed as a planned or set
route. You must be navigating for this data to appear.
Destination Location: The position of your final
destination.
Destination Waypoint: The last point on the route to the
destination. You must be navigating for this data to
appear.
Di2 Battery: The remaining battery power of a Di2
sensor.
Distance: The distance traveled for the current track or
activity.
Distance Per Stroke: Paddle sports. The distance
traveled per stroke.
Distance Remaining: The remaining distance to the final
destination. You must be navigating for this data to
appear.
Distance To Next: The remaining distance to the next
waypoint on the route. You must be navigating for this
data to appear.
Elapsed Time: The total time recorded. For example, if
you start the timer and run for 10 minutes, then stop
the timer for 5 minutes, then start the timer and run for
20 minutes, your elapsed time is 35 minutes.
Elevation: The altitude of your current location above or
below sea level.
54
Estimated Total Distance: The estimated distance from the
start to the final destination. You must be navigating for
this data to appear.
ETA: The estimated time of day when you will reach the
final destination (adjusted to the local time of the
destination). You must be navigating for this data to
appear.
ETA at Next: The estimated time of day when you will
reach the next waypoint on the route (adjusted to the
local time of the waypoint). You must be navigating
for this data to appear.
ETE: The estimated time remaining until you reach the final
destination. You must be navigating for this data to
appear.
Floors Climbed: The total number of floors climbed up for
the day.
Floors Descended: The total number of floors climbed down
for the day.
Floors per Minute: The number of floors climbed up per
minute.
Front: The front bike gear from a gear position sensor.
GCT Balance: The left/right balance of ground contact
time while running.
Gear Battery: The battery status of a gear position sensor.
Gear Combo: The current gear combination from a gear
position sensor.
Gear Ratio: The number of teeth on the front and rear bike
gears, as detected by a gear position sensor.
Gears: The front and rear bike gears from a gear position
sensor.
Glide Ratio: The ratio of horizontal distance traveled to the
change in vertical distance.
Glide Ratio to Destination: The glide ratio required
to descend from your current position to the
destination elevation. You must be navigating for this
data to appear.
GPS: The strength of the GPS satellite signal.
GPS Elevation: The altitude of your current location
using GPS.
GPS Heading: The direction you are moving based on
GPS.
Grade: The calculation of rise (elevation) over run (distance). For
example, if for every 3 m (10 ft.) you climb you travel 60 m
(200 ft.), the grade is 5%.
Graphical Cadence: A color gauge showing your
current running cadence range.
Graphical Heart Rate: A color gauge showing your
current heart rate zone.
Ground Contact Time: The amount of time in each step
that you spend on the ground while running, measured
in milliseconds. Ground contact time is not calculated
while walking.
Heading: The direction you are moving.
Appendix
Advertisement
Table of Contents
