Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Equinox Systems BLITZER
Summary of Contents for Equinox Systems BLITZER
-
Page 1: User Manual
w w w . p r o l i g h t . c o . u k Order code: STRO02 User manual... - Page 2 Equinox Blitzer Strobe Safety WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids. SAFETY INSTRUCTIONS Every person involved with the installation, operation & maintenance of this...
- Page 3 Equinox Blitzer Strobe Safety IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! •...
- Page 4 Manual Mode To run the Blitzer Strobe in Manual mode, press the ‘MODE” button to show “F--” on the LED display. Now to set the flash rate, use the “UP” and “DOWN” buttons and adjust the speed from 0-9. To set the intensity press the “MODE”...
- Page 5 DATA Cable (DMX cable) requirements (for DMX operation): • The Equinox Blitzer Strobe can be controlled via DMX-512 protocol. The DMX address is set on the back of the unit. Your unit and your DMX controller require a standard 3-pin XLR connector for data input/output (figure 1).
- Page 6 Equinox Blitzer Strobe DMX Set up Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing.
- Page 8 w w w . p r o l i g h t . c o . u k...
Need help?
Do you have a question about the BLITZER and is the answer not in the manual?
Questions and answers