Table of Contents
Advertisement
Drive System
Maintenance
Checking the Tire Pressure
Service Interval: Every 25 hours—Check tire
pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause uneven
cut. Check the pressure at the valve stem
Check the tires when they are cold to get the most
accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inflate the rear drive wheel tires to 89.6 kPa (13 psi).
Figure 40
1. Valve stem
Releasing the Electric
Brake
The electric brake releases by manually rotating
the link arms forward. Once the electric brake is
energized the brake will reset.
To release the brake:
1.
Turn the ignition key to the Off position or
disconnect the battery.
2.
Locate the shafts where the brake-link arms are
connected on both sides of the electric brake
(Figure
41).
3.
Rotate the shafts forward to release the brakes.
(Figure
40).
1. Rotate brake-link arm forward on the electric-brake-control
module
2. Left rear tire
g000554
36
Figure 41
g027911
Advertisement
Table of Contents
