Table of Contents
Advertisement
Adjusting the Height-of-Cut
Note:
The transport position is the highest
height-of-cut position or cutting height 115 mm
(4.5 inches) as shown in
Figure 15
Positioning the Steering
Wheel
The steering wheel has 3 positions for operation
and one, full-up position. Use the full-up position for
stepping on and off the machine and getting out of
the seat. When operating the machine, position the
steering wheel where you have the best control of the
machine and are most comfortable.
1.
Press your foot onto the steering-column release
lever.
2.
Position the steering wheel to the desired
position
(Figure
16).
Figure
15.
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so the rollers do
not touch the ground in normal, flat mowing areas.
1.
Disengage the blade control switch (PTO),
ensure the parking brake is engaged.
2.
Stop the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
g028025
3.
Adjust the anti-scalp rollers as shown in
17
to match the closest height-of-cut position.
1. Anti-scalp roller
2. Bolt
21
Figure 16
Figure 17
3. Flange Nut
4. Hole spacing
g027751
Figure
g010233
Advertisement
Table of Contents
