Toro TimeCutter SWX 4250 Operator's Manual page 14

Choke Control
Use the choke to start a cold engine. Pull the choke
knob up to engage it. Push down on the choke knob
to disengage it (Figure
Throttle Control
The throttle control is variable between Fast and
Slow. Moving throttle lever forward will increase
engine speed and moving throttle lever to the rear will
decrease engine speed
Blade-Control Switch (Power
Take-off)
The blade-control switch, (PTO), engages and
disengages power to the mower blades
Fuel-Presence Window
The fuel window located on the left-hand side of
the machine, can be used to verify the presence of
gasoline in the tank (Figure
Height-of-Cut Lever
The height-of-cut lever allows you to lower and raise
the deck from the seated position. When you raise the
lever (toward you), the deck is raised from the ground,
and when you lower it (away from you), it lowers to
the ground. Adjust the height-of-cut only while the
machine is not moving
Key Choice ® Switch
This switch allows you to mow in reverse when it is
activated. To activate it, turn the switch to on and
release it after the PTO is engaged. To deactivate it,
disengage the power take-off (PTO)
Operating–in–Reverse Warning
Light
The Operating–in–Reverse warning light will illuminate
whenever the KeyChoice key is used to deactivate the
operating–in–reverse interlock. It is a reminder that
the interlock system is deactivated. The light goes out
whenever the PTO is disengaged or the engine is shut
off. When the light is on, look behind and use extra
caution when backing up.
SmartPark ™ Switch
The parking brake is activated electronically.
5).
(Figure 5).
(Figure
6).
(Figure 15).
(Figure 6).
Engage the parking brake by one of the following
actions:
•
Pressing the SmartPark
(Figure 5).
•
The parking brake engages automatically when
the operator leaves the seat and the traction
control pedal is in neutral position.
•
The parking brake automatically engages 5 to 6
seconds after the ignition switch is turned to the
Off position (if not already engaged).
To disengage the parking brake, press the Smartpark
switch to the Off position with the key in the run
position.
Hour Meter
5).
The hour meter records the number of hours when
the operator is in the seat and the ignition switch is in
the ON position
1. Hour meter location behind the seat
14
™ switch to the On position
(Figure 7).
Figure 7
g017640