Table of Contents
Advertisement
8.
Raise from the seat.
Note:
The engine should remain running.
9.
Return to the seat, disengage the parking brake
by pushing the SmartPark switch to the Off
position.
Note:
The engine should remain running.
10.
Raise from the seat.
Note:
The brake should automatically engage
and the engine should remain running.
11.
Return to the seat, engage the blades by pulling
up on the blade-control switch.
12.
Raise from the seat.
Note:
The blades should disengage and the
engine should remain running.
13.
Return to the seat, and pull the blade control
switch up.
Note:
The blades should engage.
14.
Push down on the blade-control switch.
Note:
The blades should disengage.
15.
Engage the blades by pulling up on the
blade-control switch.
16.
Move traction pedal to reverse.
Note:
The blades should disengage.
17.
Engage the blades by pulling up on the
blade-control switch.
18.
Turn the Key Choice switch to On and release.
Note:
The operating in reverse light should
illuminate.
19.
Move the traction pedal to reverse.
Note:
The blades should remain engaged.
20.
Push the PTO switch to the off position.
Note:
The blades should turn off and the
reverse warning light should turn off.
21.
Engage the parking brake by pushing SmartPark
switch to the On position.
Note:
The brake should engage and the brake
light should be on.
22.
Push and release the traction pedal in either the
forward or reverse direction.
Note:
The brake should disengage and the
brake light should turn off.
23.
Raise from the seat, and push the traction pedal
to either the forward or reverse direction.
Note:
The engine should kill.
Starting the Engine
Important:
Do not engage the starter for more
than 5 seconds at a time. Engaging the starter
motor for more than 5 seconds can damage the
starter motor. If the engine fails to start, wait 10
seconds before operating the engine starter again.
Sit down on the seat and ensure the parking brake is
set
(Figure
11).
Operating the Parking
Brake (SmartPark
The parking brake is activated electronically.
Engage the parking brake by one of the following
actions:
•
Pressing the SmartPark
(Figure
5).
•
The parking brake engages automatically when
the operator leaves the seat and the traction
control pedal is in the neutral position.
•
The parking brake automatically engages 5 to 6
seconds after the ignition switch is turned to the
Off position (if not already engaged).
Disengage the parking brake by one of the following
actions:
•
Tap the traction-control pedal forward or reverse.
•
Pressing the brake switch to the Off position
(Figure
5).
18
Figure 11
™
)
™
switch to the On position
g027831
Advertisement
Table of Contents
