Cleaning; Cleaning Under The Front Of The Machine; Washing The Underside Of The Mower Deck - Toro TimeCutter SWX 4250 Operator's Manual

Figure 58
1. Rod and spring assembly
installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
5. Secure the rod and spring assembly by twisting it
so the short end of the rod can be placed behind
the front bracket welded to the deck
Important:
The grass deflector must be
spring loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
g017618
3. Rod, short end, moved
behind mower bracket
4. Short end, retained by
mower bracket.
(Figure 58).

Cleaning

Cleaning under the Front of
the Machine
Service Interval: After each use—Check and clean
the front of the mower.
Remove debris under the front of the machine with
compressed air or by hand with a brush
Note:
Do not use water to clean under the front of the
machine, this can cause build up of debris.
Washing the Underside of
the Mower Deck
Service Interval: After each use—Clean the mower
housing.
Important:
You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, under the seat, around the
engine, hydraulic pumps, and motors.
Wash the underside of the mower after each use to
prevent grass buildup for improved mulch action and
clipping dispersal.
1. Park the machine on a level surface and
disengage the blade control switch.
2. Ensure the parking brake is engaged, stop the
engine, remove the key, and wait for all moving
parts to stop before leaving the operating
position.
3. Attach the hose coupling to the end of the
mower washout fitting, and turn the water on
high (Figure 60).
Note:
Spread petroleum jelly on the washout
fitting O-ring to make the coupling slide on
easier and protect the O-ring.
44
(Figure
Figure 59
59).
g028248