Connecting Your Monitor - Iiyama ProLite TF1534MC User Manual

CONNECTING YOUR MONITOR

Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
Connect the monitor cable to the Remote Control Touch V01 (option), if necessary.
Connect the AC Adapter to the monitor and the Power Cable to the AC Adapter first and then
connect to the power source.
Turn on your monitor and computer.
 Make sure that the building installation has a circuit breaker of 120/240V, 20A (maximum).
NOTE
 The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.
 Make sure you tighten the finger screws at each end of the Signal Cable.
 The Class I pluggable equipment Type A must be connected to protective earth.
 The socket-outlet shall be installed near the equipment and shall be easily accessible.
[Example of Connection]
Remote
Control
Touch V01
(option)
Power Cable
(Accessory)
* VGA cable is not supplied with the monitor. If you use low quality VGA cable, it may cause a result
of electro-magnetic interference. Please contact the iiyama Support Centre in your country if you
wish to connect the monitor via the VGA input.
8 BEFORE YOU OPERATE THE MONITOR
<Back>
AC Adapter
(Accessory)
USB Cable (Accessory)
VGA Cable (Not included)*
HDMI Cable (Accessory)
DisplayPort Cable (Accessory)
Computer