Connecting Your Monitor - Iiyama CHROMAMAXX 21CSY Manual

CONNECTING YOUR MONITOR

A Ensure that both the computer and the monitor are switched off.
B Connect the computer to the monitor with the signal cable. (See page 26 for CONNECTOR PIN
ASSIGNMENT.)
E Connect the Power Cable to the monitor first and then to the power supply.
n The signal cables used for connecting the computer and monitor vary by the type of computer
NOTE
used. An incorrect connection may cause serious damage to both the monitor and the
computer. The cable supplied with the monitor is a
special cable is required please contact your dealer or regional office.
n For connection to Macintosh computers, contact your dealer or regional
office for a suitable adaptor.
n Make sure you tighten the finger screws at each end of the signal cable.
n Cables are connected easily by rotating the panel 90 degrees. (See page 10 for PANEL
ROTATION.)
n Cables can be bundled together inside the cover at the back of the stand. See next page
for cable wiring.
[Example of Connection]
< Back >
Computer
BEFORE YOU OPERATE THE MONITOR 7