USER MANUAL ENGLISH Thank you very much for choosing the iiyama LCD monitor. We recommend that you take a few minutes to read this comprehensive manual carefully before installing and switching on the monitor. Please keep this manual in a safe place for...
IIYAMA CORPORATION: Wijkermeerstraat 8, 2131 HA Hoofddorp, The Netherlands Model No. : PLT3238, PLT4338 We recommend recycling of used product. Please contact your dealer or iiyama service center. Recycle information is obtained via the Internet, using the address: http://www.iiyama.com You can access the Web page of diff...
Do not put any solid objects or liquids such as water into the monitor. In case of an accident, unplug your monitor immediately and contact your dealer or iiyama service center. Using the monitor with any object inside may cause fi re, electric shock or damage.
Page 5
CAUTION INSTALLATION LOCATION Do not install the monitor where sudden temperature changes may occur, or in humid, dusty or smoky areas as it may cause fi re, electric shock or damage. You should also avoid areas where the sun shines directly on the monitor. DO NOT PLACE THE MONITOR IN A HAZARDOUS POSITION The monitor may topple and cause injury if not suitably located.
SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitors and do not indicate a problem. - When you fi rst turn on the LCD monitor, the picture may not fi t in the display area NOTE because of the type of computer that is used.
Page 7
1 hour in order to clear the residual image. For all LFD products, iiyama recommends displaying moving images and utilising a moving screen saver at regular intervals whenever the screen is idle. You could also turn off the monitor when not in use to assist the prevention.
If you drop any materials or liquids such as water into the monitor when cleaning, WARNING unplug the power cable immediately and contact your dealer or iiyama service center. For safety reasons, turn off the power switch and unplug the monitor before you CAUTION clean it.
CHECKING THE CONTENTS OF THE PACKAGE The following accessories are included in your package. Check to see if they are enclosed with the monitor. If anything is missing or damaged, please contact your local iiyama dealer or regional iiyama offi ce.
UNPACKING Before unpacking your monitor, prepare a stable, level, and clean surface near a wall outlet. Set the LCD Monitor box in an upright position and open from the top of the box before removing the top cushions. Remove the carton holders. Remove the top cushion and take the accessories box and the Monitor out.
CONTROLS AND CONNECTORS : MONITOR <Back Controller> Green Normal Operation Power Indicator Orange Power Management Power Button Left / - Button Right / + Button Up Button Down Button MENU Menu Button ENTER/ Enter / Input Select Button VIDEO SOURCE <Front>...
Page 12
<Back> AC-IN External D-Sub RS232 Line in/out RJ45 HDMI HDMI IR Sensor Remote Sensor HDMI1 HDMII HDMI Connector HDMI2 DVI-D DVI-D Connector DisplayPort DisplayPort Connector D-sub VGA Connector RS232C RS232C RS232C Connector 9pin USB Touch USB Connector External IR Mini jack IR Connector Line In Mini Jack...
INSTALLATION CAUTION Follow the manual instructions for the type of mount you have selected. Refer all servicing to qualifi ed service personnel. Moving the monitor requires at least two people. Before installing, please make sure the wall is strong enough to hold the necessary weight of the display and the mount.
Page 14
[ROTATING THE DISPLAY] It is designed to be compatible in both landscape and portrait modes. ● ProLite TF3238MSC Available Not Available Landscape Portrait ● ProLite TF4338MSC Available Not Available Landscape Portrait BEFORE YOU OPERATE THE MONITOR 11...
CONTROLS AND CONNECTORS : REMOTE CONTROL ON/OFF Turns the monitor ON and OFF. INPUT Selects the source. Serve as input source buttons when Number (1-9) / the Menu is not displayed. Input source (VGA/DVI/HDMI-1/HDMI-2/DP) Number (7) / Select the Picture mode. MODE Returns to a previous menu or closes EXIT...
PREPARING THE REMOTE CONTROL To use the remote control, insert the two dry batteries. CAUTION Do not use any other batteries other than those specifi ed in this manual for the Remote Control. Do not insert old and new batteries together in the Remote Control. Make sure that the terminals match the "+"...
BASIC OPERATION Turning the monitor ON The monitor is turned On and the Power Indicator turns to Green when you press the POWER Button on the monitor or the Remote Control. The monitor is turned Off and the Power Indicator turns to Red when you press the POWER Button on the monitor or the Remote Control.
Page 18
Move the cursor vertically Select adjustment by pressing the Button while the menu page is displayed on the screen. [Monitor] [Remote Control] Move the cursor horizontally Select menu or setting, or perform the adjustment by pressing the Button while the menu page is displayed on the screen.
Page 19
Adjust the volume of sound Press the Button to adjust the volume of sound when the menu page is not displayed on the screen. [Monitor] [Remote Control] Switch the input signal Press the VIDEO SOURCE Button on the monitor or INPUT Button on the Remote Control to display the Input signal menu when the menu page is not displayed on the screen.
* Cable is not supplied with the monitor. If you use low quality Cable, it may cause a result of electro- magnetic interference. Please contact the iiyama Support Centre in your country if you wish to connect the monitor via the VGA or DVI input.
[ Network Connection ] Connecting to a LAN To set the monitor to connect to a local area network. 1. Connect a RJ45 cable to the corresponding ports on the monitor and your LAN switch or router. 2. Enter the OSD menu Setting > Control Setting. Select LAN. 3.
Change to the desired signal timing listed on page 37: COMPLIANT TIMING. Windows XP/Vista/7/8/8.1/10 Plug & Play The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs on Windows XP/Vista/7/8/8.1/10 by connecting the monitor to DDC2B compliant computer with the Signal Cable supplied.
Page 23
MULTI-TOUCH : This monitor complies with DDC2B of VESA standard. (Plug&play compliant) The MULTI-TOUCH function runs on Windows7/8/8.1/10 by connecting the monitor to DDC2B compliant computer with the USB cable supplied. TOUCH support operation system : OS Version Windows (Windows) Win 10...
OPERATING THE MONITOR To create the best picture, your iiyama LCD monitor has been preset at the factory with the COMPLIANT TIMING shown on page 37. You are also able to adjust the picture by following the button operation shown below. For more detailed adjustments, see page 28 for SCREEN ADJUSTMENTS.
Page 25
[LOCK MODE] * Available Back Controller only. Back Controller Button: Pressing and holding the MENU and buttons for about 5 seconds, will lock/unlock the Back Controller Button Lock function. Power Button: Pressing and holding the MENU and ENTER buttons for about 5 seconds, will lock/unlock the Power Button Lock function.
ADJUSTMENT MENU CONTENTS Picture Picture Picture Mode Standard Backlight Contrast Brightness Chroma Phase Sharpness Color Temp. Custom Reset ENTER Move Enter EXIT Exit Adjustment Item Problem / Option Button to Press For displaying outdoor scenery images. Vivid For general windows environment and monitor Standard default setting.
Page 27
Sound Sound Treble Bass Center Balance Volume Mute Speaker Internal Audio In Audio Source Reset ENTER Move Enter EXIT Exit Adjustment Item Problem / Option Button to Press Too weak Treble Too strong Too weak Bass Too strong Left side speaker louder Balance Right side speaker louder Too soft...
Page 28
Screen Screen Aspect Normal Adjust Screen Touch Feature ENTER Move Enter EXIT Exit Adjustment Item Problem / Option Button to Press Enlarges the picture to fi ll the screen in the vertical Normal* direction, keeping the same aspect ratio. 16:10* Displays all picture in 16:10 aspect ratio.
Page 29
Setting Setting Language English Schedule Power Save Control Setting Network Settings Advanced Information All Reset ENTER Move Enter EXIT Exit Adjustment Item Problem / Option Button to Press English English Nederlands Dutch Français French Polski Polish Language Español Spanish Russian Deutsch German Italiano...
Page 30
Typical Contrast Ratio Off Adv. Contrast Increased Contrast Ratio Not available on this model. iiyama Logo does not display when the Advanced Off monitor is turned on. Opening Logo iiyama Logo displayed when the monitor is turned on.
If the screen has a fl icker or blur, or the picture does not fi t in the display area after performing the Auto Adjust, manual adjustments are required. Both adjustments should be made by using the screen adjustment pattern (Test.bmp) obtained via the IIYAMA web site (http://www.iiyama.com). Adjust the image by following the procedure below to get the desired picture.
Page 32
Adjust the Auto Adjustment. Adjust the image manually by following procedure below when the screen has a fl icker or blur, or the picture does not fi t in the display area after performing the Auto Adjust. Adjust the V-Position so that the top and bottom of the picture frame will fi t to the display area.
Page 33
Adjust the Phase to correct horizontal wavy noise, fl icker or blur in the zebra pattern. In case the strong fl icker or blurs remain on a part of the screen, repeat steps NOTE because the Clock Frequency may not be adjusted correctly. If the fl icker or blurs still remain, set the refresh rate of computer to low (60Hz) and repeat steps from again.
POWER MANAGEMENT FEATURE The power management feature of this product complies with power saving requirement of VESA DPMS. When activated, it automatically reduces unnecessary power consumption of the monitor when your computer is not in use. To use the feature, the monitor needs to be connected to a VESA DPMS compliant computer. There is a power management step the monitor takes as described below.
MONITOR or if the problem persists. 3. If you are experiencing a problem which is not described below or you cannot correct the problem, discontinue using the monitor and contact your dealer or iiyama service center for further assistance. Problem...
RECYCLING INFORMATION For better environment protection please don't dispose your monitor. Please visit our web site: www.iiyama.com/recycle for monitor recycling. Recycling information 33...
APPENDIX Design and specifi cations are subject to change without prior notice. SPECIFICATIONS : ProLite TF3238MSC Technology Projected capacitive 12points Light transmission Touch Hardness Screen Thickness Communication system USB serial transfer Size Category 32" Panel technology Size Diagonal: 32" (80cm) Pixel pitch 0.3637mm H ×...