Rear Panel - Yamaha SY35 Product Manual

REAR PANEL

DC 10V-12V IN Jack
[POWER] Switch
PHONES Jack
OUTPUT R and
L/MONO Jacks
FOOT VOLUME Jack
12
The DC output cable from the supplied AC Adaptor should be connected here.
When connecting the power supply, make sure that the SY35 POWER switch is
in the OFF position (extended), then plug the AC adaptor output cable into the
DC 10V-12V IN jack, and finally the adaptor's AC plug into a convenient AC
wall outlet. The cable clip located immediately below the DC 10V-12V IN jack
helps to prevent accidental unplugging of the power supply during use. Wrap the
DC cable firmly around the clip a few centimeters from the plug end.
Do not attempt to use a different AC adaptor to power the SY35.
The use of an incompatible adaptor may cause irreparable dam-
age to the SY35, and might pose a serious shock hazard!
Slide to the "ON" position to turn power ON.
Accepts a standard pair of stereo headphones (1/4" stereo phone plug) for
headphone monitoring of the SY35 sound without the need for external amplifi-
cation equipment.
These are the main stereo outputs from the SY35. If a plug is inserted only into
the L/MONO jack, the left and right-channel signals are combined and delivered
via this jack (for connection to a monaural sound system).
An optional Yamaha FC7 foot controller connected here can be used for volume
control.