Yamaha SY35 Product Manual page 68

VOICE VECTOR
Details: Step 1 is the first step recorded and step
50 is the last. Experience will give you a feel for
relating specific points in a dynamic vector to the
corresponding steps.
X-axis & Y-axis
Summary: These parameters define the position of
the currently selected step on the X and Y axes
of the level vector control range.
Settings:-31 . . . 0 . . . + 3 1
Procedure: After selecting the step to be recorded
as described in the previous function, use the
cursor keys to place the underline cursor
under the X or Y parameter. Use the [-1/NO]
and [+1/YES] keys to set the value as required.
Details: On the X (D-C) axis, a setting of -31
places the step as far as possible toward the D
element while a setting of +31 places it as far as
possible toward the C element. The Y (A-B)
axis values work in the same way: a setting of
-31 places the step as far as possible toward
the B element while a setting of +31 places it as
far as possible toward the A element. In both
axes a setting of 0 places the step at center
position.
12
Time
Summary: Multiplies the vector rate setting of the
current level vector step only. Also allows vec-
tors to be looped or ended at the current step.
Settings: 1 ... 254, Rep, End
Procedure: Use the
place the underline cursor under the rightmost
value on the lower display line (Time). Use the
[-1/NO] and [+1/YES] keys to select the re-
quired time value, repeat, or end.
Details: Time values multiply the vector rate set-
ting for the current step. If the vector rate
parameter is set to 30ms, for example, setting
the time parameter to 2 results in a step length
of 60ms, setting it to 3 results in a step length of
90ms, and so on. Since the maximum time value
is 254, extremely long steps can be created.
If you select the "End" setting, the vector will
end at the current step.
The "Rep" setting causes the vector to loop
back to the first step from the current step, re-
peating continuously.
cursor keys to