Steering - Pro-Line Boats BAY Series Owner's Manual

Fig 1 helm

Steering

Your Pro Line is equipped with a self contained hydraulic steering system. When the
steering wheel is turned the helm pump pumps fluid to the steering cylinder, causing the
boat to turn. Always check the operation of the steering before starting the engine.
Periodically check the fluid level and fill if necessary. Beware of adding too much fluid
especially if the ambient temperature is cold because subsequent expansion could cause
leaking or damage to your system (refer to manual in packet). Every 24 hours of
operation check all nuts, caps, and hose fittings for tightness. Check that the hoses are not
chafing, or kinking on sharp corners. Also check that hose ends are not damaged or
distorted by the clamps.
The fluid should be changed yearly under normal conditions, twice yearly for heavy use.
If your steering does not operate properly first check for; drive entanglements, fluid
level, hoses / fittings for leaks, and / or air in the system.
Instruments
Your Pro Line's instrumentation will vary from model to model and engine to engine,
therefore the following descriptions are general; refer to your engine manual for
specifics.