Maintenance And Servicing; Daily Maintenance; Periodic Inspection; Disposal - TE Connectivity HT11K Operating Instructions Manual

8 Maintenance and servicing

8.1 Daily maintenance

The following daily maintenance tasks should be performed by the responsible operator:
Using a soft, clean brush or a lint-free cloth, remove dirt, dust, moisture and other residue from the tool.
Do not use any hard or abrasive tools or materials that could damage the tool.
Ensure that all fixing pins are firmly seated.
Coat all pins, pivot points and bearing surfaces with a film of good quality SAE 20 engine oil. Do not lu-
bricate excessively.
When the hand tool is not needed, close the handles and store it in a clean and dry location.

8.2 Periodic inspection

The hand tool should be inspected periodically by suitably qualified staff according to the level of use,
and the inspections should be documented.
Ensure that all fixing pins are firmly seated.
Close the handles until the ratchet mechanism releases and the handles open. Ensure that the tool han-
dles open freely.
Check the hand tool for wear and damage, particularly in the crimping nest areas and the pivot points.

9 Disposal

In case of disposal, please send the hand tool and its components back to the address specified in
section 10.1 Contact Information.

10 Customer support address

TE Connectivity
c/o Schenck Technologie- und Industriepark GmbH
Landwehrstrasse 55, Building 83
64293 Darmstadt
Field Service EMEA@te.com
GATD Customer Service Hotline: +49-6151-607-1518
©2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
14/14
Operating Instructions
2-744017-4
Rev A2