Table of Contents
Advertisement
2.1
BoosterPack Board Top View
Figure 2-1 Table 2-1
board.
Table 2-2
describes the J2 configuration of the CC3000 evaluation module (EM) board.
and
Table 2-4
describe the signals on J11 and J12.
Part Name
CC3000MOD
Antenna
J1
J2
J11
J12
J13
6
CC3000 BoosterPack Evaluation Board
CC3000 BoosterPack Evaluation Board
describe the key parts and jumpers mounted on top of the CC3000 BoosterPack
Figure 2-1. BoosterPack Board Top View
Table 2-1. Key Parts of CC3000 BoosterPack Board Top View
Core module for performance evaluation (for more information, see the CC3000 module
datasheet)
Can be used for radiated testing by reworking the capacitor to correct pads
U.FL RF connector used for conductive power tests
Used to swap between test mode and operation mode. When pins 2 and 3 are shorted, J2 runs in
operation mode. When pins 1 and 2 are shorted, J2 runs in test mode.
Through-hole test points (for more information, see
Through-hole test points (for more information, see
Used to switch between external power and power from the motherboard. Can be used for power
measurements. Connect pins 1 and 2 for power from the LaunchPad flash programmer and
debugging tool. Connect pins 2 and 3 for external power.
Copyright © 2012, Texas Instruments Incorporated
SWRU331 – November 2012
Description
Table
2-3)
Table
2-4)
SWRU331 – November 2012
Submit Documentation Feedback
Chapter 2
Table 2-3
SWRU331-001
Advertisement
Table of Contents
