To Do The Product Settings - Gardena R45Li Operator's Manual

guide function (R38Li, R40Li, R45Li, R50Li) on
page 26 .
Note: The product always runs to the left of the
guide wire (as seen facing the charging station).

3.9 To do the product settings

The product has factory settings but the settings
can be adapted to each work area.
3.9.1 To get access to the menu
1. Push the STOP button.
2. Enter the PIN code on the keypad.
3. Push the MENU button.
3.9.2 To do the timer settings
3.9.2.1 To calculate the timer setting
1. Calculate the dimension of your lawn in m
2
yd .
2 2
2. Divide the m / yd of the lawn with the
approximate operation capacity. Refer to
table below.
3. The result is equal to the number of hours
that the product must operate each day.
Note: The operation capacity is approximate and
timer settings can be adjusted.
22 - Installation
Model
R38Li
R40Li
R45Li
R50Li
R70Li
R80Li
Example: A lawn of 500 m
R80Li.
2
500 m / 47 ≈ 10.5 h.
2
600 yd / 56 ≈ 10.5 h.
Days / h / day
week
7 10.5
3.9.2.2 To set the timer
1. Do steps 1–3 in
on page 22 .
2. Use the multi-choice buttons to move
through the menu structure to select
3. Use the multi-choice buttons to select
hours 1 or Work hours 2 .
4. Enter the time with the number buttons.
2
/
OK .
5. Push
6. Use the multi-choice buttons to select
days .
7. Use the multi-choice buttons to select the
days that the product will operate.
OK .
8. Push
3.9.2.3 To reset the timer setting
You can remove all timer settings and use the
factory setting. The factory timer setting lets the
product operate all hours each day of the week.
Timer and Standby on page 28 .
Refer to
1. Do steps 1–3 in
on page 22 .
2. Use the multi-choice buttons to move
through the menu structure
timer .
Approximate operation ca-
2 2
pacity, m / yd / h
33 / 39
33 / 39
38 / 45
42 / 50
44 / 52
47 / 56
2 2
/ 600 yd , cut with a
Timer settings
07:00-17:30 / 7:00
am - 5:30 pm
To get access to the menu
Timer .
Work
Work
To get access to the menu
Timer > Reset
968 - 002 -