To Do The Product Settings - Gardena SILENO city Operator's Manual

forming on the lawn. Refer to
point on page 25 .
Note: The product always runs to the left of the
guide wire (as seen facing the charging station).
If the distance on the left side of the starting point
is less than 0.6 m / 2 ft. the calibration process is
interrupted. For the widest possible guide
corridor, make sure that the distance from the
starting point to the boundary wire is minimum
1.35 m / 4.5 ft. (perpendicular to the guide wire).

3.10 To do the product settings

The product has factory settings but the settings
can be adapted to each work area.
3.10.1 To get access to the menu
1. Push the STOP button.
2. Use the up/down arrow buttons and the
OK button to enter the PIN code.
3. Push the MENU button.
3.10.2 To do the schedule settings
3.10.2.1 Wizard
The wizard is a quick tool to find suitable
schedule settings for your lawn.
1. Enter your estimated lawn size. It is not
possible to enter a larger lawn size than the
maximum work capacity.
2. Push the OK button to confirm the lawn size.
By entering your lawn size the wizard
suggests either a suitable daily schedule (go
to step 4) or need input for inactive days.
3. Choose what day(s) the product should be
inactive. Use the up/down arrow buttons to
shift between days.
22 - Installation
To set the starting
4.
5.
6.
Note: To change the schedule settings for
individual work days use the
Advanced menu.
3.10.2.2 To calculate the schedule setting
1.
2.
3.
Note: The operation capacity is approximate and
schedule settings can be adjusted.
Model
1250 m
1000 m
750 m
500 m
250 m
Example: A lawn of 500 m
SILENO life specified for 1250 m
500 m
600 yd
Days /
week
7
Push the OK button to confirm the chosen
inactive day(s).
The wizard suggests a daily schedule for the
active days. If you want to move the
schedule interval to earlier or later in the day
then push the arrow buttons up or down.
Push the OK button to confirm the daily
schedule. An overview of the daily schedule
is presented. Push the OK button to go back
to main menu.
Schedule -
Calculate the dimension of your lawn in m
2
yd .
2 2
Divide the m / yd of the lawn with the
approximate operation capacity. Refer to
table below.
The result is equal to the number of hours
that the product must operate each day. The
number of hours includes both operation
and charging time.
Approximate operation
capacity, m
2
60 / 72
2
61 / 73
2
62 / 74
2
41 / 49
2
45 / 54
2
/ 600 yd
2
/ 60 ≈ 8.5 h.
2
/ 72 ≈ 8.5 h.
h / day Schedule settings
8.5 07:00 - 15:30 / 7:00
am - 3:30 pm
953 - 002 - 12.12.2018
2
/
2 2
/ yd / h
2
, cut with a
2
.