After The Installation Of The Product; To Do The Product Settings - Gardena SILENO minimo Operator's Manual

7. Put the boundary wire or the guide wire into
position with stakes.
8. Connect the charging station to the power outlet.

3.9 After the installation of the product

3.9.1 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on the
charging station has a green light.
2. If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
Indicator lamp in the charging station on page 36
To install the charging station on page 17 .
and

3.10 To do the product settings

Use the GARDENA Bluetooth
settings for the product. The functions have factory
settings that are applicable for almost all work areas, but
the settings can be adapted to the conditions for each
work area.
3.10.1 To download and pair with the
GARDENA Bluetooth
The GARDENA Bluetooth
mobile device. The GARDENA Bluetooth
for the settings and operation of the product. The short-
range interaction with the product is called Bluetooth
When pairing between the product and app has been
confirmed, you have access to the menus and functions
as long as you are within short-range (Bluetooth
20 - Installation
®
App to set all the
®
App
®
App is a free app for your
®
App is used
®
).
1. Download the GARDENA Bluetooth
mobile device.
2. Switch off the product and switch it on again.
3. Pair the GARDENA Bluetooth
product.
Note:
The Bluetooth
3 minutes.
4. Enter the PIN code. Refer to
22 .
3.10.2 To do the Schedule settings
You can set the schedule in 3 different procedures:
• Use the GARDENA assisted scheduling where you
enter the size of your work area and the
scheduling wizard shows an applicable schedule.
• Use the Manual scheduling to set or adjust the
schedule manually.
• Use the Start/Schedule button to set a daily
schedule that starts this current time each day and
the product will operate to its maximum cutting
time each day. Refer to
operate in Main area and make a daily schedule
on page 23 .
CAUTION:
than it is necessary to prevent wear on the
product and the lawn.
3.10.2.1 Make an estimate of the necessary operating
time
If the work area is less than maximum product capacity,
the schedule must be set to decrease the wear on the
lawn and the product. The product has a maximum
cutting time each day. You can set the operating time of
the product in the schedule. The operating time includes
cutting, searching and charging. The operating time can
be different because of many reasons, for example the
layout of the work area, the grass growth and age of the
battery. When the product has operated to the maximum
cutting time in a day, the message
complete is shown in the display of the app.
The recommended operating times for some work area
examples are shown in the table below. If the result is
not satisfactory, increase the operating time.
2
Area, m
250
®
.
500
®
App on your
®
App with the
®
pairing mode is active for
PIN code on page
To set the product to
Do not cut the lawn more
Today's mowing
Recommended operating
time, h
4-5
10-11
1585 - 002 - 08.12.2020