Dexter Laundry T-675 EXPRESS PLUS Operator's Manual page 47

DRIVE COMMUNICATION
Condition
Action
Exit
DRIVE ENABLE
Condition
Action
Exit
DOOR SHUT, NOT LOCKED
Condition
Action
Exit
SLOW SPIN
Condition
Action
Exit
SPIN TIME
Condition
Action
Exit
SLOW FILL
8514-290-001 REV E page 47
This error occurs the control cannot communicate with the VFD.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met.
The machine will not start and the Error Code will continue to be
displayed until the condition no longer exists and the prompt is
followed to Reset the Error Code and return the Machine to Idle
Mode.
This error occurs when the control sees a message that the VFD
Enable circuit is not closed.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met.
The machine will not start and the Error Code will continue to be
displayed until the condition no longer exists and the prompt is
followed to Reset the Error Code and return the Machine to Idle
Mode.
This error occurs when the Door Locked signal is not received
within 1 second after the start of the cycle.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be
displayed until the prompt is followed to Reset the Error and
return the machine to Idle mode.
This error occurs when the motor does not reach a target
frequency while accelerating, within a specified time.
When detected, the control turns off the motor and machine
motion stops.
The machine will not start, and the Error Code will continue to be
displayed until the prompt is followed to Reset the Error and
return the machine to Idle mode.
This error occurs when the motor does not reach a target
frequency while decelerating, within a specified time.
When detected, the control turns off the motor and machine
motion stops.
The machine will not start, and the Error Code will continue to be
displayed until the prompt is followed to Reset the Error and
return the machine to Idle mode.