Washer Error Messages - Dexter Laundry T-675 EXPRESS PLUS Operator's Manual

5

WASHER ERROR MESSAGES

The O-Series washer control reacts to various abnormal conditions by
displaying an Error message. These messages usually contain the "Error"
text, and then a general description of the message. Below is a listing of
Error messages separated by each potential displayed message in bold
face. Each is followed by:
 Condition that creates the displayed message on the control
 Action that the control takes responding to the condition
 Exit is the method the user (or the control) should use to bring the
machine back to normal operation.
The actual displayed message on the control may contain the general
description listed below and additional details (such as number or
additional text). However, the condition, action or exit qualities of the
error message should be the same for all variations.
OPERATION IN PROGRESS
Condition
Action
Exit
POWER LOSS
Condition
Action
Exit
BROWN OUT
Condition
Action
Exit
8514-290-001 REV E page 41
This error occurs when the user is attempting to start a machine
operation while another operation is ending.
When detected, the control does not respond to user input on the
buttons. There is no delay in the action once the criteria are met.
The control will finish the current operation while displaying
"OPERATION IN PROGRESS". Once the operation is complete, the
error will no longer be displayed and the control will respond to
user input normally.
The error will be reset automatically once the current operation is
complete.
This error occurs when the Main Control Board detects a total loss
of 24VAC power.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met.
The machine will not start and the Error Code will continue to be
displayed until the condition is no longer present. Once the
condition is removed, the machine still will not start and the Error
Code will continue to be displayed until the prompt is followed to
Reset the Error and return the machine to Idle Mode.
This error occurs when the Main Control Board detects less then
21VAC at the 24VAC input.
When detected, the control turns off the motor and all relays.
There is no delay in the action once the criteria are met.
The machine will not start and the Error Code will continue to be
displayed until the condition is no longer present. Once the
condition is removed, the machine still will not start and the Error
Code will continue to be displayed until the prompt is followed to
Reset the Error and return the machine to Idle Mode.