– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when
the plug is plugged in.
– Do not use a multi-socket extension ca-
ble, multi-socket plug, travel adapter, ex-
tension cable or similar.
– We recommend using a pulse-sensitive
residual current device (RCD).
• Insert the mains plug into the socket.
Installation
NOTICE
Risk of damage to property!
By selecting incorrect screws, you may
damage adjacent kitchen units.
■ Use the screws which are supplied in
the delivery or screws of an appropri-
ate length.
1. Disconnect the power supply at the fuse
box.
2. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
(c)
3. Affix the enclosed condensation -protec-
tive film (c) to the underside of the work-
top. In this way you will avoid damage to
the work surface as a result of hot steam
flowing out of the dishwasher if the door
is left open.
Installation, fitting, connection
(g)
4. Insert the two mounting brackets (g)
into the front slots on the top of the dish-
washer so that you can subsequently
screw the dishwasher to the worktop.
5. Remove the protective films from the
side end profiles (e).
6. Affix the end profiles to the left and right
edges of the dishwasher. This will pre-
vent a crack being visible between the
dishwasher and the adjacent kitchen
cupboards.
Page EN-31
(e)