Hanseatic HGU4582D10J7710EI User Manual page 76

Page EN-32 Installation, fitting, connection
1/2
7. Push the dishwasher into the recess.
8. To enable the dishwasher to be posi-
tioned levelly, both front and back appli-
ance feet can be adjusted by up to 5 cm.
– Both front feet are equipped with slots.
Insert a screwdriver into one of the
slots and use it to turn the appliance
feet to the desired height.
– You can use the middle adjustment
screw (30) to adjust the height of the
rear appliance foot. Use a Phillips-tip
screwdriver for this.
9. Check the alignment with a spirit level.
10. Make sure the top edge of the dish-
washer is up to the bottom edge of the
worktop to prevent it from tipping forward
when you open the dishwasher door.
11. Screw the dishwasher to the kitchen
unit.
(30)
(g)
(i)
(h) (i)
– If you have granite worktops, remove
the internal side cover caps (h) and
screw the dishwasher to the adjacent
kitchen cupboards.
Replace the cover caps on the round-
head screws (i).
– For all other worktops, screw the
mounting bracket (g) firmly to the work
surface.