Power down the server blade (on page 16).
3.
Remove the server blade (on page 17).
4.
Loosen the thumbscrew on the rear of the access panel.
5.
Press down on the thumb indentations, slide the access panel toward the rear of the unit about 1.25
6.
cm (0.5 in), and lift to remove the access panel.
Remove the secondary access panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and
the internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server blade before
beginning any installation procedure. Improper grounding can cause ESD.
Identify the proper server blade in the server blade enclosure.
1.
Back up all server blade data.
2.
Power down the server blade (on page 16).
3.
Remove the server blade (on page 17).
4.
Loosen the two thumbscrews on the rear of the access panel.
5.
Press down on the thumb indentations, slide the access panel toward the rear of the unit about 1.25
6.
cm (0.5 in), and lift to remove the access panel.
Operations 18