Reliability, Availability, And Serviceability Features - IBM 8038 Installation And User Manual

v Large system-memory capacity
v Light path diagnostics
v PCI Express
v Power throttling

Reliability, availability, and serviceability features

Reliability, availability, and serviceability features help to ensure the integrity of the
data that is stored in the blade server, the availability of the blade server when you
need it, and the ease with which you can diagnose and correct problems.
Three of the most important features in server design are reliability, availability,
and serviceability (RAS). These RAS features help to ensure the integrity of the
data that is stored in the blade server, the availability of the blade server when you
need it, and the ease with which you can diagnose and correct problems.
The blade server has the following RAS features:
v Advanced Configuration and Power Interface (ACPI)
v Built-in diagnostics using DSA Preboot, which is stored in integrated USB
v Built-in monitoring for temperature, voltage, and hard disk drives
v Customer support center 24 hours per day, 7 days a week
1. Service availability will vary by country. Response time will vary depending on the number and nature of incoming calls.
8
BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide
The blade server has connectors on the system board for optional expansion
cards for adding more network communication capabilities to the blade server.
The blade server system board supports up to 192 GB of system memory. The
memory controller provides support for up to twelve industry-standard
registered ECC DDR3 on Very Low Profile (VLP) form factor DIMMs installed
on the system board. For the most current list of supported DIMMs, see the
®
ServerProven list at http://www.ibm.com/systems/info/x86servers/
serverproven/compat/us/ .
Light path diagnostics provides light-emitting diodes (LEDs) to help you
diagnose problems. For more information, see the Problem Determination and
Service Guide.
PCI Express is a serial interface that is used for chip-to-chip interconnect and
expansion adapter interconnect. With the blade expansion connector you can
add optional I/O and storage devices.
Each blade server is powered by two Enterprise Voltage Regulator-Down
(EVRD) 12.0 voltage regulators. By enforcing a power policy known as
power-domain oversubscription, the BladeCenter unit can share the power load
between two power modules to ensure sufficient power for each device in the
BladeCenter unit. This policy is enforced when the initial power is applied to the
BladeCenter unit or when a blade server is inserted into the BladeCenter unit.
The following settings for this policy are available:
– Redundant without performance impact
– Redundant with performance impact
– Nonredundant
You can configure and monitor the power environment by using the Advanced
Management Module. For more information about configuring and using power
throttling, see the Advanced-Management-Module documentation or
http://www.ibm.com/supportportal/ .
memory
1