Table of Contents
Advertisement
Figure 8: Chiller Power Switch
Figure 9: Back Panel Description
5. With the controller turned on, the fan will start to spin. The pump will energize, prime, and
begin to move fluid.
At first, the low light flow will flash on and off during the priming process. The system is
capable of self-prime, establish flow and bleed excess air back into the reservoir without
intervention.
6. When the pump is properly primed the orange light will be illuminated on the right side of the
chiller display [PUMP SET].
1314-900 Revision BA
Figure 10: Display indicating properly primed
pump
250W Precision Calorimeter
3-Coolant Supply (OUT)
4-Coolant Return (IN)
7-Air Exhaust
9-On/Off Switch
10-Fuse (5 x 20 mm, slow blow)
11- AC Input
12-RS-232 port (Chiller Serial)
13-External RTD sensor connector
14-Internal/External RFD Switch
13
Advertisement
Table of Contents
