Setting Up; Unpacking; Check Package Contents; Charging The Internal Battery - Silvercrest SKHO 50 B2 Operating Instructions Manual

Setting up

Unpacking

♦ Unpack all parts of the device from the packaging and remove all packaging materi-
als.

Check package contents

(See fold-out page for illustrations)
The following components are included in delivery:
Bluetooth
®
●
● USB charging cable (Micro USB to USB Type A )
● Audio cable (3.5 mm jack plug)
● Quick start guide
● These operating instructions
NOTE
► Check the package for completeness and signs of visible damage.
► If the delivery is incomplete or damage has occurred as a result of defective packag-
ing or during transport, contact the Service hotline (see section Service).

Charging the internal battery

NOTE
► Before using the headphones, the integrated battery must be completely charged.
CAUTION
► Charge the headphones only in dry indoor spaces.
► Use only the supplied USB charging cable
► Disconnect the USB charging cable
♦ Make sure that the headphones are switched off. To switch off the headphones,
press the
7
ing LED
♦ Connect the USB plug on the USB charging cable
USB port on your computer.
♦ Connect the micro USB plug of the USB charging cable
ing socket DC IN
│ GB │ IE
■ 8
headphones
4
button for about 2 seconds until a beep sounds and the operat-
goes out.
r
on the headphones.
q
to charge the headphones.
q
when charging is complete.
q
to a USB mains adapter or a
q
to the micro USB charg-
SKHO 50 B2