Silvercrest SKHO 50 B2 Operating Instructions Manual page 19

The following table helps to identify and rectify further possible faults:
Fault
The head-
phones cannot
be switched on.
No sound.
Sound is only
coming from
one side of the
headphones.
NOTE
► If you cannot solve the problem with the solutions given above, please contact the
Service Hotline (see section Service).
│ GB │ IE
■ 16
Possible cause
The internal battery is
not charged.
The headphones are
not switched on.
The volume is set to
minimum.
The playback device
is not switched on.
The playback device
has been muted.
w
The audio cable
incorrectly connected
in AUX-IN mode.
The stereo balance
control on the
playback device is
incorrectly adjusted.
Remedy
Charge the battery (see section Charging the
battery).
Press the
to switch on the headphones.
Set the desired volume using the
3
button . If necessary, also increase the
volume on the playback device.
Switch on the playback device.
Unmute the playback device.
is Make sure that the audio cable
connected to the AUX IN socket
headphones and the playback device.
Adjust the stereo balance control to the setting
you desire.
4
button for about 2 seconds
w
8
SKHO 50 B2
is correctly
of the