SilverCrest Wireless Headphones RFH 1863
Setting the Wireless Channel
Under unfavourable circumstances, the audio signal may be subject to
interference. This may happen when you are using a baby phone or other
wireless headphones nearby. In this case it is recommended that you switch
to another channel.
Set the transmitter cradle to a different channel by sliding the selection
switch (1) on its back panel to a different position (e.g. "Channel 1").
Power on the audio source that you have connected to the device. The
send indicator (16) on the transmitter cradle should light blue.
Slide the mode selection switch (7) of your headphones to the "WL"
position.
Power the wireless headphones on by pressing the On/Off button (13)
once.
Press the Search button (5) on the headphones as many times as
necessary until you can hear the sound over the headphones. After the
channel has been synchronised, the wireless link status indicator (8) will
light green.
Each press of the Search button (5) will toggle the
headphones one channel up, and will cycle to the first
one after Channel 3 (Channel1 -> Channel2 -> Channel3
-> Channel1 -> ...).
12 - English