Panel Setting Check - Daikin ZUWCM/DM Installation And Maintenance Manual

SINGLE SCREW CHILLERS IMM
Installation Position※
Upper Part of Evaporator
Upper Part of Evaporator
Lower Part of Evaporator
Bottom of evaporator head
Top of evaporator head
Rear of Evap. (near Cond)
Top of condenser
Bottom of condenser
Left of Cond (facing starter)
Bottom of evaporator head
Top of condenser head
Top of oil separator
Bottom of oil separator
Bottom of oil separator
Suction Pipeline
Oil Return Pipeline
Liquid Supply Pipe
Suction-type Oil-spray Pipeline Stop valve of Suction-type Oil-spray Pipe (if any)
Liquid-spray Pipeline
Balance Pipeline
Notes: ※ Please refer to the orifice table in container as-built drawing for specific positions of
each stop valve.
※※ The setting of safety valve is of great importance. Please check the stability of the safety
valve carefully. Refer to [4.4 Notes for Relief Valve]

7.6 Panel setting check

Check if setting values are matched the chiller.
Before chiller start-up, bring panel settings into correspondence with customer system.
Enter "System settings" interface to set parameters (password is requested).
28
Engineered for Flexibility and Performance
Description of Valve Application
Safety Valve
Refrigerant charging valve
Pollution discharging valve
Drain valve
Vent valve
Oil return valve
Refrigerant discharging valve
Pollution discharging valve
Liquid control valve
Drain valve
Vent valve
Safety Valve
Oil discharging valve
Pollution discharging valve
Suction valve (if available)
Drainage tube ball valve (if available)
Liquid supply valve
Liquid-spray Pipeline Stop Valve (if any)
Balance Pipe Stop Valve (if any)
On-off State
On ※※
Off
Off
Off
Off
On
Off
Off
On
Off
Off
On※※
On
Off
On
On
On
On
On
On