Network Setup Via Front Panel; Configuring Ip Mode (Static Or Dhcp) - Sencore Impulse 300E User Manual

1
3
1. Screen title.
2. Icons indicate which control buttons are currently valid for entry.
3. Cursor shows which line is active.
4. When editing, active character or item is highlighted.
3.2

Network Setup via Front Panel

The Impulse 300E can be setup on a network connection to allow remote management
and SNMP configuration. For these features to work, the network settings for the
Impulse 300E must first be configured properly for the network it is connected to. By
default, the Impulse 300E follows this configuration scheme:
•
Network 1:
o Mode: DHCP
•
Network 2:
o Mode: Static
o IP Address: 10.0.0.72
o Subnet Mask: 255.255.255.0
o Gateway: 0.0.0.0

Configuring IP Mode (Static or DHCP)

To setup the Impulse 300E with a static IP address, use the following steps:
1. Press the button (twice if the front
panel is in "Idle" mode).
2. Use the and
move the cursor to "Admin", then press
the button.
3. Use the and
move the cursor to "Unit Networking",
then press the
Page 18 (74)
Impulse 300E – User Manual
Adapter Config 1
IP Mode: Static
IP: 0.0.0.0.
>Mask: 0.0.0.0
Gateway: 0.0.0.0
buttons to
buttons to
button.
↔↕
Input: MPEG/IP 0.000 Mbps↔↕
Output: MPEG/IP 0.000 Mbps
Network 1: 0.0.0.0
Network 2: 0.0.0.0
Main Menu
>Admin
Active Errors
About System
Admin
>Unit Networking
Profile
2
4
↔↕
↔↕