Adjusting The Volume From Your Legacy Remote - Lionel VISION Baggage Car Owner's Manual

LEGACY and Command Control Remote
Operations

Adjusting the volume from your LEGACY remote

I
n addition to the physical volume control on the underside of your VISION baggage car (see page
4), your remote can be used to adjust the overall volume, or just the volume of the background
sounds (which include muffled bumping and banging as the car starts or changes speed, sharp
grinding metallic sounds of wheel flanges against the track, and rhythmic "ca-klunk" simulating the
sound of each axel crossing over rail joints).
Pressing the volume up or down buttons (see pages 11 or 15) adjusts the overall volume of your
baggage car. A single bell ring will be heard each time the volume is raised or lowered, except that no
ring will be heard once the volume reaches the minimum or maximum levels.
To adjust only the levels of the background sounds in LEGACY mode, such as bumping, banging,
metallic, or "ca-klunk" sounds:
1. If assigned to a Train, press Train Link, or address your baggage car directly by pressing ENG and
its ID.
2. Press AUX1 first, then press the volume up or down keys on your remote.
3. Press the Train Link button to continue controlling your train.
In this case, a metallic thwack sound will confirm the background or "blend" sound volume is being
adjusted. Again, this confirming sound will not be heard when the background/blend sound volume
reaches its minimum or maximum level.
Note!
To adjust the overall volume of the baggage car, follow the instructions above except do
not press AUX1. Only press the volume up or down buttons.
Note!
Be aware that if your Min/Max switch is in the Min position, adjusting the master volume
or blend volume from your remote will have essentially the same result.
16