Lionel VISION Baggage Car Owner's Manual page 10

Table of Contents

LEGACY and Command Control Remote

Operations

Setting up your VISION baggage car in your CAB-2 remote continued

Using Train Link

To send a command specifically to your baggage car, such as a coupler command or to trigger load-

ing/unloading, press the Train Link button (see page 11 for button location). Notice that the keypad

has changed. It should appear like the screen below.

Select one or more commands then press the Train Link button to continue controlling your train.

In order to send commands directly to your baggage car, you must press Train Link. The

Note!

remote will show the screen above. In this mode, the train itself (ie. the engine) will not

respond because you are sending commands directly to the diner car.

If you wish to control the train press Train Link again. In this mode you will be able to adjust speed,

apply the train brake, access TowerCom and CrewTalk, blow the engine's horn or whistle, and ring the

engine's bell.

VISION BAGGAGE

CAR COMMANDS

Table of Contents