Indicator Warnings - Brother P950NW User Manual

Troubleshooting

Indicator Warnings

Problem
Received data in buffer
Head is cooling down
Machine is in boot mode
Errors concerning tape cassettes
I want to reset an error
Solution
Print data is saved in the buffer. If the machine has not received the
complete data, printing will not start.
Turn the machine off, and then turn it on again.
The thermal head is too hot.
The machine stops and resumes printing only after the thermal
head has cooled down. The head may become too hot if you are
printing a large number of labels.
When the thermal head becomes too hot, it may produce imaging
on the labels in areas not intended to be printed. To avoid or delay
overheating, make sure the machine has adequate ventilation and
is not located in an enclosed space.
If the machine must cool down because it overheated due to the
type of tape cassette you are using or the contents of the label,
printing may take longer than usual.
Note
This condition may occur more often when the machine is used
at high altitude (more than 10,000 ft (3,048 m)) due to a lower
air density available to cool the machine.
To resolve the issue, contact your Brother dealer or Brother
customer service for assistance.
Check the following:
 You are using the correct tape cassette.
 There is enough tape remaining.
 The tape cassette is installed correctly.
I want to reset an error
1 Open the top cover, and then close it.
2 If the error is not reset, press the
3 If the error still is not reset, turn the machine off, and then turn it
on again.
4 If the error still is not reset, contact Brother customer service.
(Feed&Cut) button.
168
18
18