Serial (Rs-232C) Cable (Windows Only); Serial Interface Settings - Brother P950NW User Manual

Using the Other Interfaces (Serial Interface/Bluetooth Interface)

Serial (RS-232C) Cable (Windows Only)

Serial (RS-232C) cables are not standard accessories.
Note
• For serial interfaces, a shielded interface cable should be used to ensure compliance with the limits for
Electromagnetic Compatibility (EMC).
• Changes or modifications not expressly approved by Brother Industries, Ltd. may affect the performance
and print quality, and damage may not be covered under the limited warranty.
The pin assignments for the serial cables (RS-232C cables) that can be used with this machine are shown in
the table below. You can purchase the cables at an electronics store. Do not use a serial cable that is longer
than (2.0 m).
PA-SCA-001 side
(D-sub female, lock screw #4-40 inch screw)
Signal Name
DCD
RXD
TXD
DTR
GND
DSR
RTS
CTS
RI

Serial Interface Settings

Use the following steps to change or confirm the port and the baud rate settings on the barcode scanner or
scale and the machine.
Setting the Barcode Scanner or Scale Baud Rate
For more information on setting the baud rate, see the instruction manual for the barcode scanner or scale.
Setting the Machine Baud Rate (Windows Only)
To set the machine baud rate, see Preparation on page 67. For more informaton, download P-touch
Template Manual/Command Reference (English only) from the Brother support website at
support.brother.com
[Select your region/country.] - [Manuals] - [Choose your product]
Pin Number Pin Assignments
1
2
3
4
5
6
7
8
9
Barcode scanner or scale side
(D-sub 9-pin female)
Pin Number Signal Name
1
2
3
4
5
6
7
8
9
4
4
DCD
RXD
TXD
DTR
GND
DSR
RTS
CTS
RI
4
4
4
24