Table of Contents
Advertisement
Free from materials detrimental to paint use such as silicone.
Operational temperature -40 °C to 90 °C or higher.
Meets the requirements of all relevant standards (design, identification).
The internal hose fittings must be of austenitic stainless steel, outer fittings of galvanised
and yellow chromated steel.
Operating pressure > max. allowable excess pressure of diaphragm pump
Connection thread normally G1.
In most cases the material pressure connection is joined to the diaphragm pump by a pipeline
The connection must be flexible (avoids fracture caused by vibration stresses).
Non-return valve
Flexible
pressure pipeline
Pipeline
In an expanded material pressure system and in cases where the pressure system is
influenced by heat (sunrays, heating, etc.) it is necessary to fit a suitable non-return
valve in the pressure pipeline (to prevent damage caused by heat expansion).
All metal parts of the pressure and suction accessories supplied by us which come in
contact with the material are of austenitic stainless steel. They are suitable for use with
water lacquer.
F APPLIANCE SUPPORT
A wall fixing and a frame support the 003.175-DP diaphragm pump.
The characteristics of the flexible pressure line:
Minimum nominal diameter 25
Operating pressure > max. allowable diaphragm
pump excess pressure
Operating pressure > max. allowable diaphragm
pump excess pressure
Operational temperature 10 to 90 °C
For areas subject to danger of explosion:
Electrically conductive, leakage resistance to
earth < 10
Fig. 5
The following applies to the surface coating :
resistant to normal solvents and free from
materials detrimental to paint use such as
silicone.
8
6
B.6.50.80-B-GB
Advertisement
Table of Contents
