IPD Power Supply and DC Power Option
The IPD power supply is shipped with all instruments that have the DC power option.
Some AC-only instruments may also include this power supply.
Before you can remove the IPD power supply, you must first do the following:
Then remove the power supply as follows:
1. Using a #2 Pozidriv screwdriver, remove the12 screws from the power-supply
TFP2A FiberMaster Module-Level Service Manual
Remove the top and bottom covers of the instrument.
Disconnect the power-supply cable from the control board.
Remove the printer tray.
Remove the CRT/display assembly
cover and lift out the power supply
Figure 4-42. Removing the IPD Power Supply
Chapter 4: Maintenance
4-89