Toro 03668 Operator's Manual page 9

lithium-based grease
excess grease, specifically around the excluder
seals.
Installing the Brush on Cutting
Units Equipped with Groomers
Note:
If a groomer kit and a brush kit are going to be
installed on the cutting unit, install the groomer kit first.
1. Remove the 2 groomer cover mounting nuts and
remove the cover
1. Groomer cover
2. Remove the 2 flange nuts (5/16 inch) securing
the groomer weight to the groomer cover and
remove the weight
(Figure 19). Wipe off any
Figure 19
(Figure 20).
Figure 20
2. Cover mounting nut (2)
(Figure 21).
1. Groomer weight (remove)
2. Groomer cover
g009062
3. Solid grommet (remove)
3. Remove the solid grommet from the cover and
replace it with the rubber grommet ring
21).
4. Remove the 2 screws (5/16 x 1-1/4 inch)
threaded into the cover
5. Remove the set screw from the center hole in
the groomer cover
1. Groomer cover
g009063
6. Install the previously removed set screw and
the set screw included with the Groomer Kit,
into the holes previously used for the cover
mounting screws. Apply 242 Loctite (blue) to the
set screws prior to installation.
Note:
The set screws should be flush with the
groomer cover.
7. Install the groomer cover and secure with 2
flange nuts (5/16 inch)
9
Figure 21
4. Rubber grommet ring
5. Cover screws (remove)
6. Set screw (2)
(Figure 21).
(Figure 21).
Figure 22
2. Grommet
(Figure 22).
g009064
(Figure
g009065