Toro 03668 Operator's Manual page 10

Important:
Do not over tighten the nuts.
8. Apply grease to the inside diameter of the
grommet in the groomer cover
9. Remove the 2 nuts securing each roller bracket
to the side plates
the bolts.
Note:
Remove any 6 mm (1/4 inch) spacers
positioned on the top side of the side plate
mounting flange.
1. Remove nuts securing
each end of roller
2. 6 mm (1/4 inch) spacer
10. Position the roller brush assembly mounting
brackets onto the roller bracket bolts
24). Secure the brush assembly mounting
brackets to the cutting unit side plates with the
nuts previously removed.
1. Roller brush assembly
(Figure
(Figure 23). Do not remove
Figure 23
3. Side plate mounting flange
(Figure
Figure 24
Important:
mounting brackets must be mounted directly
to the top surface of the cutting unit side
22).
plate mounting flange. Do not put spacers
on the roller brush mounting brackets and
the side plate mounting flanges. Install
additional 6 mm (1/4 inch) spacers on the
top side of the roller brush mounting bracket
(Figure
g009053
1. Roller brush mounting
bracket
2. Cutting unit side plate
mounting flange
11. Slide each excluder seal outward until the lip
seals are in light contact with each bearing
housing
g009067
10
The roller brush assembly
25).
Figure 25
3. Extra 6 mm (1/4 inch)
spacers
(Figure 26).
g009055