Advertisement
Media and Additional Parts
Description
Operator's Manual
Parts Catalog
Note:
Determine the left and right sides of the cutting
unit from behind the cutting unit.
Important:
The Rear Roller Brush Kit is only to
be used when cutting in the height of cut range of
6 to 25 mm (1/4 to 1 inch). Use the High Height of
Cut Brush, Part No. 110–1740 when cutting above
25 mm (1 inch). Refer to
Height of Cut Brush (Optional) (page
Rear Roller Brush Kit Model 03668 may be used
on the following:
Cutting Unit Models 03661, 03694, and 03695 for the
Reelmaster 5210 or 5410 Traction Units.
Rear Roller Brush Kit Model 03688 may be used
on the following:
•
Cutting Unit Models 03681, 03682, 03693, 03696
and 03697 for the Reelmaster 5510 or 5610
Traction Units.
•
Cutting Unit Models 03863, 03864, 03698 and
03699 for the Reelmaster 6500 or 6700 Traction
Units.
Note:
If a groomer kit and a brush kit are going to be
installed on the cutting unit, install the groomer kit first.
Qty.
1
1
5 Installing the High
14).
Read before installing and operating.
Use to look up replacement parts.
1
Determining the Roller
Brush Orientation
No Parts Required
Procedure
All cutting units are shipped with the counter weight
mounted to the left end of the cutting unit. Use the
following diagram to determine the position of the
roller brush and reel motors.
Note:
These instructions and illustrations show the
installation of the kit on cutting units with the end
weights mounted on the left end of the cutting unit.
2
Use
Figure 1
g009047
Advertisement
