Toro 03668 Operator's Manual page 3

2
Reposition the Idler Pulley
Assembly
No Parts Required
Procedure
On the left front and left rear cutting units, reverse the
idler pulley assembly to mount on the right end of the
cutting unit (Figure 2), as follows:
1. Remove the idler pulley assembly from the left
end of the cutting unit and mount it to the lower
hole in the brush plate on the right end of the
cutting unit (Figure
Note:
The idler pulley must pivot freely; do not
over tighten the locknut on the idler pivot bolt.
2. Remove the carriage bolt and nut and relocate
them to the upper hole previously occupied by
the idler pulley assembly
1. Idler pulley installation for
left end of reel
2. Idler pulley installation for
right end of reel
2).
(Figure 2).
Figure 2
3. Carriage bolt and nut
4. Do not overtighten this
locknut
3
Remove Brush Cover Drain
Plug
No Parts Required
Procedure
Remove only the bottom drain plug
the brush covers. This allows moisture to drain from
the belt area.
1. Brush cover
g351961
3
(Figure 3) from
Figure 3
2. Bottom drain plug
g009049