Toro 03668 Operator's Manual page 11

1. Excluder seal
2. Bearing housing
12. Loosen but do not remove the bolts securing the
roller brush bearing housing to the roller brush
mounting bracket
13. Install the roller brush pivot plate
Ensure that the grommet stays properly seated
on the cover when the protrusion on the pivot
plate is inserted into the grommet on the
groomer cover.
Note:
The roller brush pivot plate is properly
seated when there is no resistance from the
rubber grommet and it pivots freely.
1. Shoulder bolt
2. Brush plate
3. Bolt
4. Grommet in bearing
housing
Figure 26
3. Mounting bracket
(Figure 27).
(Figure
Figure 27
5. Roller brush mounting
bracket
6. Flange lock nuts
7. Roller brush bearing
housing
14. Apply 242 Loctite (blue) to the 2 bolts (5/16 x
5/8 inch) and use them to mount the brush plate
to the roller brush bearing housing
Torque the bolts to 20 to 25 N-m (15 to 19 ft-lb).
15. Check to make sure that the roller brush plate is
parallel to the cutting unit side plate. If it is not
parallel, do the following:
•
Loosen the 2 flange locknuts securing the
roller brush mounting bracket to the cutting
unit side plate
•
Rotate the roller brush bearing housing until
the brush plate is parallel to the cutting unit
side plate
•
Tighten the 2 flange locknuts securing the
roller brush mounting bracket to the cutting
g009056
unit side plate
16. Loosen the 2 bolts securing each roller brush
bearing housing to the roller brush mounting
bracket
27).
1. Loosen these bolts.
g352187
1. Loosen these bolts.
11
(Figure 27).
(Figure 27).
(Figure 27).
(Figure 12 and Figure
Figure 28
Figure 29
(Figure 27).
13).
g009078
g009079