Advertisement
6.
Mount the roller brush housing to the reel
bearing housing with 2 Allen Head Bolts (3/8
x 1 inch)
(Figure
6). Position the roller brush
housing so that the threaded hole is toward the
front of the cutting unit.
Note:
Make sure that the O-ring is properly
positioned in the roller brush housing.
Figure 6
1. Roller brush housing
2. Threaded hole in housing
7.
Remove the 2 flange locknuts securing each
roller bracket to the side plates
Note:
Do not remove the bolts. Also, remove
any 6 mm (1/4 inch) spacers positioned
on the top side of the side plate mounting
flange.
Figure 7
1. Remove nuts securing
each end of roller
2. 6 mm (1/4 inch) spacer
g009052
3. Yellow O-ring
(Model 03668)
Black O-ring (Model
03688)
(Figure
7).
g009053
3. Side plate mounting flange
8.
Position the roller brush assembly mounting
brackets onto the roller bracket bolts
Secure the brush assembly mounting brackets
to the cutting unit side plates with the nuts
previously removed.
1. Roller brush assembly
Important:
The roller brush assembly
mounting brackets must be mounted directly
to the top surface of the cutting unit side
plate mounting flange. Do not put spacers
between the roller brush mounting brackets
and the side plate mounting flanges. Install
additional 6 mm (1/4 inch) spacers on the
top side of the roller brush mounting bracket
(Figure
9).
5
(Figure
Figure 8
2. Roller brush mounting
bracket
8).
g009054
Advertisement
