Toro 03668 Operator's Manual page 14

5
Installing the High Height
of Cut Brush (Optional)
No Parts Required
Procedure
Install the High Height of Cut Brush, Part No.
110–1740 when cutting above 2.5 cm (1 inch)
height-of-cut (i.e., 5 or more spacers installed below
the side plate pad).
1. If a roller brush is installed on the cutting unit,
remove the 2 bolts, washers and nuts securing
the non–drive bearing housing to the bearing
housing mounting bracket
(Figure 37).
Figure 36
1. Non–drive bearing housing
2. Slide the non–drive bearing housing and
excluder seal off the brush shaft
(Figure 36) and
g009073
(Figure 37).
14
Figure 37
1. Non–drive bearing
housing
2. Excluder seal
3. Remove the 2 J-bolts and nuts
4. Slide the existing brush off the brush shaft
(Figure 38).
5. Loosen the 2 bolts, washers, and nuts securing
the drive bearing housing to the bearing housing
mounting bracket
6. Slide the high height of cut brush onto the brush
shaft (Figure 38).
7. Clamp the brush onto the shaft with the 2 J-bolts
and nuts previously removed
Important:
Insert the threaded end of the
J–bolts thru the outer holes of the brush
shaft while hooking the curved ends of the
J–bolts into the inner holes.
8. Torque the J–bolt lock nuts to 2 to 3 N-m (20
to 25 in-lb).
3. Brush shaft
(Figure 38).
(Figure 38).
(Figure 38).
g009074