Advertisement
4
Installing the Roller Brush
Parts needed for this procedure:
1
Roller brush housing (for use without a groomer)
Allen head bolt, 3/8 x 1 inch (for use without a
2
groomer)
1
Roller brush assembly
1
Shoulder bolt
1
Belt cover/plate assembly
2
Bolt, 5/16 x 5/8 inch
1
Spacer (for use without a groomer)
1
Drive pulley
1
Flange head bolt, 3/8 x 2 inches
1
Belt
O-ring (yellow) (used without a groomer with Brush Kit
1
Model 03668 only)
1
Shim washer (as required for belt alignment)
Installing the Brush on Cutting
Units not Equipped with Groomers
Use this procedure if the cutting unit is not
equipped with groomer. If the cutting unit is
equipped with a groomer, proceed to
Brush on Cutting Units Equipped with Groomers
(page 9)
for the installation instructions.
1.
Park the traction unit on a level surface and
engage the parking brake.
2.
Ensure that the cutting units are disengaged.
Turn the engine off and remove the key. Remove
all cutting units from the traction unit.
Important:
Check the cutting unit for
desired height-of-cut and attitude. Reset
per Operator's Manual, if required, before
installing Rear Roller Brush Kit.
3.
Remove the 2 bolts securing the counter weight
to the left end of the cutting unit. Remove the
counter weight
(Figure
Installing the
4).
1. Counter weight
4.
Using a 3/8-16 tap, remove the paint in the outer
mounting holes in the side plate
5.
On Roller Brush Kit Model 03668 only, install
the yellow O–ring onto the roller brush housing
(Figure
5).
Note:
On Roller Brush Kit Model 03688, a black
O-ring is already installed.
1. Roller brush housing
4
Figure 4
2. Clean out these mounting
holes
(Figure
Figure 5
2. Yellow O-ring
(Model 03668)
Black O-ring (Model
03688)
g009050
4).
g009051
Advertisement
